| Microphone/Line Inputs |
|
Four, balanced. Phantom power available |
| Preamp Gain (total path) |
|
+25dB to +70dB Total path gain |
| Line Input Impedence |
|
20K Ohms, balanced to ground |
| Common Mode Rejection |
|
Mic Input/45dB Gain = 100dB, Line In = >70dB |
| Freq Response (All Paths) |
|
20-20KHz, +/- 0.5 dB |
| Microphone Channel EIN |
|
125 dB, bandwidth-limited to 25KHz |
| System Signal/Noise |
|
100 dB below peak level, bandwidth-limited to 25KHz |
| A-D and D-A Conversion |
|
24-bit, 48KHz |
| Digital Processing |
|
24-Bit, 48KHz, ARM 32-bit DSP |
| IFB Outputs |
|
2 channel wet RTS-format or single-channel dry +4dB nom. |
| IFB DC Current |
|
Sufficient to power two RTS IFB beltpacks |
| PL Interface (Booth End) |
|
2 channel wet RTS-format. DC current to support 3 beltpacks |
| PL Interface (Truck End) |
|
4-wire dry +4dBm nominal. 8 assignable 4W Ports |
| PL Trans-hybrid Loss |
|
Greater than 55 dB |
| Remote Control |
|
From ADX-2400 or front-panel RS232 |
| Network Transmission Format |
|
20-bit Cobranet, Low-latency mode |
| Path Latency |
|
2.25 Milliseconds-all paths (analog to analog) |
| Network Transmit Channels |
|
Six: Input 1, Input 2, Input 3, Input 4, PL1-TX, PL2-TX |
| Network Receive Channels |
|
Six: IFB1, IFB2, PGM1, PGM2, PL1-RX, PL2-RX. |
| Front Panel Switches |
|
Two-digit rotary ID switches. No other panel controls |
|
| System Addressing |
|
Front panel two-digit rotary switches. Address 01-99 |
| Bundle Numbers |
|
Set automatically based on System Address |
| Network Interface |
|
100baseT Ethernet (redundant RJ45 ports) Layer 2 |
| Ethernet Bandwidth Required |
|
Approximately 8 megabits/sec each direction per ADX-140 |
| Power Requirements |
|
48 Volts, 225 MA with no beltpacks. 350 MA with four beltpacks, or AC (95-250V) |
| Cabinet Dimensions |
|
19" Wide, 9" Deep, 1.75" High. (1 Rack Unit) |
| Weight |
|
Approx. 3 Pounds |
